2025/10/30 5M Servo Motor Encoder Cable for Mitsubishi M64 System OSA104 OSE104 HC202, Sales records with pictures and video
On this page
What is the 5M encoder cable for the Mitsubishi M64 system (OSA104 / OSE104 / HC202)?
This is a five-metre servo motor encoder cable built for Mitsubishi's M64 CNC system — the OSA104 / OSE104 / HC202 pairing that runs between an HC202-series servo motor and its drive. The cable ships coiled in a sealed bag as a new replacement with a one-year warranty, and the photo set shows its three fittings: a right-angled military-style plug with its screw-down mounting clamp (the motor-end fitting that bolts to the encoder cover), a high-density blade connector with lock-screw ears (the drive-side plug), and a straight round plug with a 26-socket face on a metal threaded shell. The heavy black jacket is wrapped and tied for the coil. It passed through the Koeed warehouse on 30 October 2025 (about 1 kg per the record); the seven photos and video below show it as received.
Part details
| Field | Value |
|---|---|
| Fits | Mitsubishi M64 CNC system — HC202 servo motor encoder link, OSA104 (motor end) / OSE104 (drive end) connector styles |
| Length | 5 metres, heavy black jacket, coiled and bagged |
| Motor-end fitting | Right-angled military-style plug with a screw-clamped mounting bracket |
| Drive-side fitting | High-density blade connector with lock-screw ears |
| Additional fitting | Straight round plug, 26-socket face, metal threaded shell |
| Condition | New, sealed (per intake record); one-year warranty |
| Weight | About 1 kg (record) |
| Intake recorded | 30 October 2025 |
Fitting notes
Encoder cables fail by flexing at the plug, so the useful details are in the fittings: the angled motor plug with its clamp brackets bolts flat against the encoder cover so the cable strain lands on the bracket, not the solder joints, and the drive-side blade connector locks to the amplifier face with its two screws before the cable is dressed. Route the 5-metre run away from the motor power cable — encoder signals are low-level and the M64 will throw an alarm on any coupled noise — and leave the service loop loose at the drag-chain end. Because this is a replacement harness built to the OSA104/OSE104 pin-out, verify continuity pin-for-pin against the old cable before powering up; the photos let you check each plug shell and keyway against the originals before the machine goes down.
Photos and video
All images below are original warehouse photos of the exact cable covered by this record, taken before dispatch. Click any photo to view it full size.
Sourcing help
KOEED supplies Mitsubishi CNC cables and servo spares, in active and EOL stock. Send the part number for a quote.
Need a quote for this part?
Send us the part number or article link — we will confirm price, availability and lead time.
