p1244-5651: delivery record

The p1244-5651 source record contains a motor controller. Its front label reads “SEP EXCITED D.C. MOTOR CONTROLLER”; the reviewed photographs do not support the original article’s PLC description. The source identifier is retained, although it is not visible on either reviewed face.

Identification and delivery details

The first photograph shows a black ribbed enclosure with large threaded power terminals and three connector positions marked J1, J2 and J3. A round status lens sits beside the blue label. These visible features identify connection points for comparison; they do not provide a wiring assignment, operating voltage or current rating.

The second photograph shows a rectangular silver-coloured metal baseplate with corner mounting holes. There is no readable identity label on that face. Hole spacing, overall dimensions and the thermal interface need measurements from the offered unit rather than estimates from the photograph.

The selected record dated 4 December 2025 describes domestic manufacture in China and records 5 kg. It does not state a condition grade or warranty term. The weight’s scope is unspecified, so it should not be treated as a verified net weight for one controller.

No complete manufacturer name or p1244-5651 marking is established by the first two photographs. The printed motor-controller category is stronger evidence than the old PLC text, but it does not establish the controller’s exact variant or an interchangeable replacement.

All seven distinct source photographs and the recorded clip are retained. The two reviewed stills provide an exterior inspection; motor operation, programming support and an installed-system test remain outside that evidence.

Swipe or scroll horizontally to read the full table.

Photographs 1 and 2 establish the motor-controller label and baseplate. The p1244-5651 identifier and manufacture description come from the selected source record.

Matching this part

Send the existing controller’s full label, motor identification and application requirements. Confirm the exact manufacturer and model, supply range, motor type, connector assignments and any configuration needed before comparing a replacement.

Ask for offered-unit label photographs and measured mounting dimensions. Specify acceptable condition and required test evidence. The J1/J2/J3 marks alone cannot confirm pin assignments or compatibility with an existing harness.

Photos and recorded media

Recorded inspection clip. The clip is retained as delivery evidence; no performance measurement is inferred from it.

Related records and products

Send the existing unit’s labels and connection requirements through Koeed contact details.