GTX1080 1080ti: High-Performance GPU Solutions for Industrial Automation and PLC Systems

24 de janeiro de 2026

Historical parts record: Photos and notes below belong to this record. Confirm the offered unit’s full model, condition and available test evidence before ordering.

This listing is not a complete GPU — it is the EVGA cooler assembly for the GeForce GTX 1080 Ti: the silver metal shroud with the GEFORCE GTX 1080 Ti engraving, dual EVGA-branded axial fans, the full copper-base heatsink stack, two backplates, the fan Y-splitter cable, and the screw set. The PCB is not included, so it suits a board repair or a custom build where the original cooler was lost. Everything is new, with the protective film still on the shroud; received 2025-12-17, one kit, about 1 kg packed, sold without warranty.

What is in the kit

Part	Detail
Shroud / top shell	Silver cast metal, GEFORCE GTX 1080 Ti engraving, EVGA top badge
Fans	2 × axial, EVGA logo on hub, 9 blades each, 4-pin drive
Heatsink	Copper base plate (factory phase-change pad fitted), aluminum fin stacks, flattened heat pipes
Backplates	Main backplate + airflow shroud plate (AEVC marking), thermal pads pre-fitted
Cables	Fan Y-splitter (dual fans to one 4-pin header)
Hardware	Screw set in a sealed bag

GTX 1080 Ti cooler close-up — Cooler end-on: the fin stack, flattened heat pipe and the 4-pin fan connector on its lead.

GTX 1080 Ti cooler base and backplates — The full stack apart: copper base with the factory phase-change patch dead center, thermal pads on every memory and VRM position, and the two backplates to the left — one with the AEVC airflow marking, the other plain with its QR label.

Shroud and fans

GTX 1080 Ti shroud engraving — The shroud face: GEFORCE GTX 1080 Ti engraved into the silver casting, with the EVGA mark on the fan hub below.

EVGA GTX 1080 Ti top badge — Top edge: the EVGA GEFORCE GTX 1080 Ti badge plate, still under its protective film.

Video: the kit rotated on the bench — shroud, fans, base and backplates in turn.

Details

GTX 1080 Ti fin stack side — Along the fin stack: the fan lead exits between the mounting arms, spring-loaded screws for the base clamp visible below.

GTX 1080 Ti backplates — Both backplates with thermal pads already seated — the smaller plate covers the card's rear section, the larger one carries the AEVC airflow cutouts.

GTX 1080 Ti cooler full kit — The whole kit as delivered: dual-fan cooler assembly with REMOVE PROTECTIVE FILM BEFORE USE stickers, fan Y-cable, and the sealed screw bag.

GTX 1080 Ti side light bar — Side angle: the white LED light guide along the shroud edge, spring screws on the base plate, and the fan connector.

GTX 1080 Ti kit from above — From above: both fans under their protective film, with the Y-cable and screw bag laid out alongside.

Fitment notes

This is the EVGA SC2-class cooler for reference GTX 1080 Ti PCBs — the base clamp, screw positions and backplate holes follow the reference layout. If your donor card runs a custom PCB, verify hole spacing against the base clamp before committing. The Y-cable drives both fans from the card's single fan header; fan speed then follows GPU temperature as on the original card.