EG-101P Digital Counter: Advanced Measurement and Control Solution for Industrial Automation

13 январь 2026 г.

Historical parts record: Photos and notes below belong to this record. Confirm the offered unit’s full model, condition and available test evidence before ordering.

What is the Mitutoyo EG-101P?

The EG-101P is Mitutoyo's counter display unit (Code No. 542-015) — the panel counter that reads Mitutoyo's linear gauge sensors and drives sorting or eject decisions on a measuring line. The face carries the identity and the whole operator interface: Mitutoyo over the EG-10P marking, the UNIT and BANK status LEDs, the TIR / MAX / MIN measurement legends, and the four-key row — BANK, Fn, MODE, P.SET — over a double-height display. The rear is the working half: a 6-pin DIN INPUT socket for the gauge, a DB25 parallel OUTPUT port for the PLC or sorter, the DC IN 12-24 V 500 mA terminal block, and the label with Code No. 542-015, Model EG-101P, serials 008951 and 003329, Mitutoyo Corporation, Made in Japan (Kawasaki). Two units, second-hand pulls at 90% condition, 3-month warranty as recorded at intake. All 4 photos below show these exact units.

2 min readContent reviewed 8 October 2026

Part details

EG-101P, as printed on the face and rear label
Field	Value
Model	Mitutoyo EG-101P (face marking EG-10P)
Code number	542-015 (rear label)
Type	Counter display unit for Mitutoyo linear gauge sensors
Input	6-pin DIN socket (gauge input), INPUT marked
Output	DB25 parallel port, OUTPUT marked; +V / −V terminals
Supply	DC IN 12-24 V, 500 mA
Face	UNIT / BANK LEDs, TIR / MAX / MIN legends, BANK / Fn / MODE / P.SET keys
Serials	008951, 003329
Origin	Made in Japan — Mitutoyo Corporation, Kawasaki
Quantity	2 units, second-hand pulls, 90% condition; 3-month warranty as recorded at intake

Scroll sideways to see the full table.

Values are read from the face marking, the rear label and the photographed construction in the photo set.

What the EG-101P does on a measuring line

Mitutoyo's linear gauges — the probing heads that ride a machined surface and report displacement — need a counter to turn their signal into a number, a tolerance band and a go/no-go decision, and the EG-101P is that counter. The BANK system is its working core: each bank holds a set of preset values and tolerances, so an operator can switch between part programmes with the BANK key while Fn and MODE page the functions and P.SET writes the presets — the measuring cell re-armed for the next part in seconds. The TIR, MAX and MIN legends mark the measurement modes the unit runs — total indicator runout and the peak-hold functions that checking a bore or a journal requires. On the back, the DB25 parallel port hands the judgement to the line: pass, over, under, wired straight into the PLC that opens the good-part gate. Made at Mitutoyo's Kawasaki works, these two pulled units at 90% condition are the pragmatic grade for a measuring station whose display has died — the gauge and the fix are both still in production lineage, and the counters photographed here are tested pulls, not shelf rust.