KLÜBER to Mobil Industrial Gear Oil Cross-Reference Table
| KLÜBER Product | Equivalent Product | Compatibility & Notes |
| Klubersynth GEM 4-220 N | Mobil SHC Gear 220 | Both PAO synthetic with EP chemistry. GEM 4 N has enhanced anti-micropitting per FVA 54/7. |
| Klubersynth GEM 4-320 N | Mobil SHC Gear 320 | Both PAO synthetic ISO VG 320. Both have wind turbine OEM approvals. Verify specific gearbox OEM list. |
| Klubersynth GEM 4-460 N | Mobil SHC Gear 460 | Both PAO synthetic. For cement mill and heavy industrial gear drives. |
| Klubersynth GEM 4-680 N | Mobil SHC Gear 680 | Both PAO synthetic. High viscosity for heavily loaded, low-speed industrial gear drives. |
| Klubersynth GH 6-220 | Mobil SHC Gear 220 | Both PAO synthetic ISO VG 220. GH 6 is general industrial; SHC Gear has additional EP additives. |
| Klubersynth GH 6-460 | Mobil SHC Gear 460 | Comparable PAO synthetic gear oils. Verify micropitting and bearing wear test requirements. |
Reference: Published product datasheets from KLÜBER Lubrication and Mobil. Verify with current datasheets before substitution.
⚠ Important Disclaimer
This cross-reference is provided for informational purposes only. Equivalent does not mean identical — differences in thickener type, base oil viscosity, additive packages, and NLGI grade can affect performance. Always verify technical compatibility by consulting both manufacturers' datasheets and obtaining OEM approval before substituting lubricants. Contact KOEED for verified KLÜBER product recommendations matched to your specific application requirements.
> Tip
When cross-referencing, always verify: (1) thickener compatibility — mixing incompatible thickeners can cause grease to soften or harden, (2) base oil viscosity at operating temperature, (3) NLGI grade for proper consistency, (4) certification status (NSF H1, ISO 21469) for food-grade applications. If in doubt, contact KOEED for a verified recommendation.
Frequently Asked Questions
Q: Can I mix Klubersynth GEM with Mobil SHC Gear in the same gearbox?
Both are PAO-based synthetic gear oils and are miscible. However, mixing different additive packages can dilute the performance of both products. For best results, drain and refill with a single product. If topping up, limit the mixed volume to less than 10% of the total fill. Monitor oil analysis results closely after any product mixing.